Section 5: User Interface - Taylor 490 Operator's Manual

Section 5
4
Table 5-1
Item
1 Control Switch
2 ADD MIX Indicator
3 MIX OUT Indicator
4 RESET Button
Control Switch
The center position is off. The right position is auto, which
activates the beater motor and the refrigeration system.
The left position is wash, which activates the beater
motor only.
Mix Level Indicators
The mix level indicators are located on the front of the
machine. When the MIX LOW indicator is flashing, the
mix hopper has a low supply of mix and should be refilled
as soon as possible.
User Interface
1
Description
2
Figure 5-1
When the MIX OUT indicator is flashing, there is no mix
in the hopper. The compressor stops running until the mix
is replenished. This eliminates possible damage to the
beater, blades, drive shaft, and door.
Reset Button
The reset button is located on the left side panel. The
reset button protects the beater motor from overloading.
If an overload occurs, the reset mechanism will trip.
To properly reset the freezer, place the control switch in
the OFF position. Press the reset button firmly. Place the
control switch in the WASH position and observe the
freezer's performance. The beater motor should operate
without tripping the overload. Once satisfied, place the
control switch back in the AUTO position.
Model 490
User Interface
3
5
5-1