Related Manuals for Tesvor S6
Summary of Contents for Tesvor S6
- Page 1 The expert for robots in your home With one click to the online shop myRobotcenter.eu myRobotcenter.co.uk myRobotcenter...
- Page 3 Note：Please track the first test run of the robot and help troubleshoot few tiny problems to guarantee a successful cleaning. Do not stand in front of the robot during the test. Hinweis: Bitte verfolgen Sie den ersten Testlauf des Roboters und helfen Sie bei der Behebung einiger kleiner Probleme, um eine erfolgreiche Reini- gung zu gewährleisten.
-
Page 4: Table Of Contents
CONTENTS 1. Safety Instructions 2. What’s in the Box 3. Using Your S6 Important Tips before Use Preparation LED Indication Charging Modes Switching Modes Cleaning Modes Set Time and Scheduled Cleaning 4.Cleaning and Maintenance S6 Anatomy Clean the Rolling Brush... - Page 5 To reduce the risk of injury or damage, read these safety instructions carefully and keep them at hand when setting up, using, and maintaining this device. Safety Instructions for S6 and Accessories Warning 1. Do not disassemble, repair or refit the product without authorization;...
- Page 6 Please recycle the battery safely for environmental protection. Safety Instructions for S6 and Accessories Danger 1. Always use a dedicated battery adapter to avoid leakage, heating or rupture.
- Page 7 11. The power supply must be removed from the socket-outlet before cleaning or maintaining the device. 12. The battery must be removed from the device before it is scrapped. 13. The device must be disconnected from the mains supply when removing the battery.
-
Page 8: What's In The Box
2. What’s in the Box Main Body Remote Control Charging Base Power Adapter (2 * AAA Batteries required but NOT included) High-effective Cleaning Tool Side Brushes(4) Filter/Sponge Water Tank Component While the accessories provided for some models are slightly different, they are subject to the actual product. -
Page 9: Using Your S6
Remove power cords and small objects from the floor that may become entangled with the S6. The S6 may climb on top of objects less than 0.63 in/16 mm in height. Remove these objects if possible. Do NOT stand around narrow places, such as thresholds and aisles, to reduce the uncovered rate. -
Page 10: Preparation P7
Preparation Install the side brushes before use. Please note L and R should correspond to each other when installing the side brushes. Turn on the main power switch on the side of S6. Remove before use Remove the protective film before use. - Page 11 Install 2 AAA batteries (Not included in the package) into the remote control. Power On/Off Display Screen Return for Auto Plan Cleaning Charging Confirm Direction Clock Settings Suction Settings spot cleaning Schedule Note: For App users, please refer to our User Guide for App&Alexa. When the device is in the vicinity of the charging base and the virtual protection wall, it may not be able to receive the instructions issued by the remote control.
-
Page 12: Led Indication P9
LED Indication Indicator Light Machine Status Scene Standby / Cleaning The S6 is in Standby or Cleaning mode, running white light / Fully charged or fully charged. blinking white light Configuring mode When connecting with the app running white light... -
Page 13: Switching Modes P10
Switching Modes Note: Make sure the power switch on the side of the S6 is t urned on before use. Wake Up Sleep mode means that the S6 is stopped and the indicator light is off. If the S6 is not active for 10 minutes, it will enter Sleep mode automatically. -
Page 14: Cleaning Modes P11
Smart Cleaning mode. 2. Spot Cleaning S6 intensively cleans a specific area in a spiral pattern, useful if there is a concentrated area of dust or debris. When in the Spot Cleaning mode, the S6 will stop cleaning after 2 minutes. - Page 15 restricted area 3. Setting Forbidden Area Only available by App control, After setting the forbidden area, the robot will not enter the forbidden area of the room. Location A Location B 4. Relocation by LDS During cleaning, when pause the robot and take it to a new area ,then restart it to resume cleaning, the robot will begin relocation and move to its previous place.
-
Page 16: Set Time And Scheduled Cleaning P13
Note: Make sure the time is set correctly to your local time before setting a scheduled cleaning. 1. Make sure the main power switch on the bottom of the S6 is turned on. 2. Press on the remote control. The time will blink on the display. -
Page 17: Cleaning And Maintenance
4.Cleaning and Maintenance For optimal performance, follow the instructions below to clean and maintain the S6 regularly. The cleaning/replacement frequency will depend on the way you use the S6. S6 Anatomy Top & Side Bumper Control Button WIFI Indicator Laser Components... -
Page 18: Clean The Rolling Brush P15
Charging Base Charging indicator light DC power jack Charging terminal Dust box Pre-filter High-performance filter Filter sponge Dust box Dust box cover Clean the Rolling Brush 1.Open the rolling brush components. 2.Remove the rolling brush shaft and clean off any debris and hair. Clean the Side Brushes Foreign substances, such as hair, can easily get tangled in the side brushes, and dirt may adhere to them. -
Page 19: Clean The Box And Filters P16
2) Carefully unwind and pull off any hair or string that is wrapped between the main unit and the side brushes. 3) Use a cloth dampened with warm water to remove dust from the brushes or to gently reshape them. Only use the side brushes when they are completely dry. -
Page 20: Replace The Side Brushes P17
Replace the Side Brushes The side brushes may become bent or damaged after being used for a period of time. Follow the instructions below to replace them. Pull off the old side brushes and snap the new ones into place. Clean the Sensors and Charging Terminals To maintain the best performance, clean the drop sensors and charging terminal regularly. -
Page 21: Troubleshooting
Clean the sensors carefully with movements or the S6’s software. a dry cloth. travel path are Restart the S6 by turning the abnormal. power switch off and back on. The side The side brushes are mounted Please install the side brushes brushes deform in reverse. - Page 22 Charging Time 330mm Diameter of main unit 101mm Thickness of main unit Net weight of main unit 4.0kg 7. Customer Service If you have any issues, please contact us by Online Service on the app or send email to service@tesvor.com.
- Page 23 MORE FAMILY TIME. LESS CLEANING. Address: Humboldtstr.5, 31812 Bad Pyrmont Germany Call Us : +49 69 365065463 Mon-Fri 9AM-5PM (CET) Customer Service: service@tesvor.com Company website: h ps://www.tesvor.com/de Manufacturer: Shenzhen Zhisheng Dianzishangwuyouxiangongsi Address: Qianwan Yilu 1hao Adong 201shi Qianhai shenganghezuoqu Shenzhen Guangdong China...
Need help?
Do you have a question about the S6 and is the answer not in the manual?
Questions and answers