Set Lengths For Discrete 2 Of 5 - Symbol SE955 Integration Manual

8-50 SE955 Integration Guide

Set Lengths for Discrete 2 of 5

Parameter # L1 = 0x14, L2 = 0x15
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s) the code contains.
Lengths for D 2 of 5 may be set for any length, one or two discrete lengths, or lengths within a specific range. To set lengths via serial
commands, see Setting Code Lengths Via Serial Commands on page B-8.
One Discrete Length - Select this option to decode only those codes containing a selected length. For example, select D 2 of 5 One
Discrete Length, then scan 1, 4, to decode only D 2 of 5 symbols containing 14 characters. Numeric bar codes begin on page 8-
73. To change the selection or cancel an incorrect entry, scan the Cancel bar code on page 8-74.
D 2 of 5 - One Discrete Length
Two Discrete Lengths - Select this option to decode only those codes containing two selected lengths. For example, select D 2 of
5 Two Discrete Lengths, then scan 0, 2, 1, 4, to decode only D 2 of 5 symbols containing 2 or 14 characters. Numeric bar
codes begin on page 8-73. To change the selection or cancel an incorrect entry, scan the Cancel bar code on page 8-74.
D 2 of 5 - Two Discrete Lengths
Length Within Range - Select this option to decode codes within a specified range. For example, to decode D 2 of 5 symbols
containing between 4 and 12 characters, first scan D 2 of 5 Length Within Range, then scan 0, 4, 1 and 2 (single digit numbers must
be preceded by a leading zero). Numeric bar codes begin on page 8-73. To change the selection or cancel an incorrect entry, scan the
Cancel bar code on page 8-74.
D 2 of 5 - Length Within Range
Any Length - Scan this option to decode D 2 of 5 symbols containing any number of characters.
Selecting this option may lead to misdecodes for D 2 of 5 codes.
D 2 of 5 - Any Length