Table of Contents
Advertisement
4. Attach stationary blade (5) to mounting bracket
using two cap screws (10), four hardened flat
washers (15) and lock nuts (11).
NOTE: Stationary blade should fit between the two
rotating blades on the crossbar.
5. Replace skid shoe using existing hardware if
removed.
1. Attach mounting bracket (6) to the front side of the
front baffle and secure with cap screws (12),
hardened flat washers (14) and lock nuts (13). Do
not tighten hardware.
2. Attach stationary blade (5) to mounting bracket (6)
using two cap screws (10), four hardened flat
washers 915) and lock nuts (11). Blade should be
angled by using the first hole on the left side and
the second hole on the right side. Refer to Figure
29.
38 Assembly
Install Stationary Blades - Right and Left Wing
Figure 29. Stationary Blade Installed - Right Wing
Figure 30. Shredder Kit Installation
3. Rotate crossbar and blades so stationary blade fits
4. Repeat steps to install stationary mounting bracket
12 14
5
between the two crossbar blades. Adjust mounting
bracket (6) so the stationary blade (5) is 1" below
flat blade (4), Tighten all hardware. See Figure 29.
NOTE: Stationary blade should be parallel to the
rotating blades, point toward the center of the gear-
box and rear of cutter, and overlap rotating blades
approximately 4 inches.
(6) and blade (5) to the opposite wing.
14
13
15 10
MAN1281 (4/15/2019)
Advertisement
Table of Contents
