Woods BATWING BW20.50Q Operator's Manual page 18

Lock-Up
Always transport with wings and center frame in the
raised, locked position.
Wing Lock-Up
1. Raise wing to the up position.
2. Remove klik pin and lock pin from storage position
(Figure 2).
Figure 2. Transport Lock Pin in Storage Position
3. Place lock pin in lock position and secure with klik
pin (Figure 3).
4. Repeat steps 1 to 3 for opposite wing.
5. Release pressure on cylinder so that wing is
secured against lock pin (Figure 3).
Figure 3. Transport Lock Pin
18 Operation
Center Section Lock-Up
1. Raise cutter with hydraulic cylinder to maximum
height.
2. Remove klik pin and lock pin from storage position
(Figure 5).
Figure 4. Transport Lock Pin In Transport Position
3. Place lock pin and klik pin in lock position and
lower cutter against lock pin. See Figure 4.
• Upper hole provides higher transport height.
• Middle hole provides narrow transport width.
4. To lower cutter for operation, extend hydraulic
cylinder to raise cutter. Move lock pin from lock
position to storage position (Figure 5).
5. Lower cutter to desired cutting height.
Figure 5. Transport Lock Pin In Storage Position
MAN1281 (4/15/2019)