Tecnotion UC3 Series Manual page 5

The magnet yoke and coil unit can be damaged when cleaned
with a non-prescribed cleaning agent.
Use only isopropanol as a cleaning agent.
UV Blacklight can cause irreversible damage to the eyes
and other tissue when exposed. When using a UV Blacklight
installation wear appropriate protective clothing and glasses.
The magnet yokes do attract each other while mounting. Take
care that the closing plates of one yoke do not damage the
magnets of the neighbour magnet yoke while mounting.
If at any time and in any situation there is any doubt about
the safety of the Linear Motor, do not use it and contact your
supplier.
The Linear Motor is powered by a servo amplifier. In case of a
power disruption or fatal error this may automatically result in
a free run out of the motor. Make mechanical precautions to
prevent damage on the motor or your machine in the case of
such an event.
©2016 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior notice.
Tecnotion | www.tecnotion.com | sales@tecnotion.com
Before installing the motor, make sure that the supply mains
are grounded and operate in conformity with the regulations in
force.
Make sure that there is an effective protective earth.
Make sure that there is no voltage at the wire terminals before
connecting.
An earth connection does not work on non-conducting
mounting surfaces like granite. In these cases the protective
earth must be established by an earthing wire
Before carrying out checks or doing any maintenance, clear the
system by disconnecting the voltage. Be sure that there is no
possibility of accidental connections.
CH 1 BEFORE YOU START
5