Cleaning Instructions - Tecnotion UC3 Series Manual

step 1/5

3.2.2 Cleaning instructions

Only the cleaning of the yokes is described. The same method can be used
to clean the coils and the cables.
Initial cleaning
1.
Clean the workstation with Isopropanol cleaning wipes (IPA).
Make sure the workstation is clean.
2.
Blow filtered pressed air in to the gap between each pair of
magnets.
UV Blacklight can cause irreversible damage to the eyes and other
tissue when exposed. When using a UV Blacklight installation
wear appropriate protective clothing and glasses.
Verification of surface pollution
4.
Inspect the yoke with the blacklight installation for dust particles.
Intensive cleaning
5. Clean the workstation with IPA cleaning wipes.
6. Place the magnet yoke on the cleaned workstation.
©2016 Tecnotion BV - All rights reserved - The contents of this document are subject to change without prior notice.
step 2 step 3 step 4/11 step 7/8
3.
Blow filtered pressed air in to the side of the yoke. Repeat for
the other side.
7. Clean the yoke with a cleanroom compatible vacuum cleaner.
8. Repeat the process for the other side of the yoke.
9. Clean all sides of the magnet yoke with IPA cleaning wipes.
Only move the IPA cleaning wipe in one direction, do not move back and
forward. This will enhance the cleaning action.
10. Clean the inside of the magnet yoke with an IPA cleaning wipe
and a cotton swab.
Verification of cleaning
11. Inspect the magnet yoke with the blacklight installation for
remaining dust particles.
Especially check the areas between the magnets and the gab between the
magnets and the bottom of the yoke.
12. If dust particles are visible: Remove them with an IPA cleaning wipe
and cotton swab until the surface is cleaned to an acceptable level.
CH 3
Tecnotion | www.tecnotion.com | sales@tecnotion.com
step 9
10
INSTALLATION