Table of Contents
Advertisement
Rails
en
Second step (2_4)
Fill the water tank with 150 ml water and insert it.
1.
After operation of the rinse cycle, "3_4" appears on
2.
the display. Remove the water tank and clean
thoroughly with water.
Third step (3_4)
Fill the water tank with 150 ml water and insert it.
1.
After operation of the rinse cycle, "4_4" appears on
2.
the display. Remove the water tank and clean
thoroughly with water.
Fourth step (4_4)
Fill the water tank with 150 ml water and insert it.
1.
After operation of the rinse cycle, "3_4" appears on
2.
the display. Remove the water tank and clean
thoroughly with water.
After descaling
Dry the water tank.
1.
Reinsert the water tank.
2.
Descaling is complete and the appliance is ready for
use again.
Descaling programme interrupted
If descaling is interrupted (for example, due to a power
failure or because the appliance is switched off), the
descaling symbol appears on the display after the
appliance is switched back on. You will be prompted to
rinse three times. The appliance cannot be used for
other operations until the third rinse cycle comes to an
end. If you set another operation, "'‚Ÿ" (Cleaning)
appears on the display. Repeat the interrupted
descaling programme after rinsing.
Empty the water tank and clean thoroughly with
1.
water.
Insert the empty water tank.
2.
Use the function selector to set descaling.
3.
Turn the temperature selector.
4.
"‹Ÿ" appears on the display. After a few seconds,
the remaining liquid pumped back.
Empty the water tank and clean thoroughly with
5.
water.
To rinse the steam system, run the three rinse cycles
6.
in the descaling programme.
Restart descaling.
7.
24
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Lift the rail slightly at the front ‚ and detach it ƒ
1.
(figure
).
!
Then pull the whole rail towards you and take it out
2.
(figure
).
"
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Attaching the rails
The rails only fit on the right or the left side. For both
rails, ensure that the curved rods are at the front.
First, insert the rail in the middle of the rear socket ‚,
1.
until the rail rests against the cooking compartment
wall, and push it back ƒ (figure
).
!
Advertisement
Table of Contents
