Table of Contents
Advertisement
1. If the switch is not attached to the drier, attach it at this time. The switch only
goes on "hand Tight" use a wrench to tighten it. BE SURE TO ONLY SNUG
THE SWITCH.
2. On the passenger side inner fender well near the front of the jeep is where the
drier will mount. Be sure to mount the drier on the flat surface of the inner fender
well. With two self tapping screws secure the drier to the inner fender well.
IN as printed on the top of
the drier.
RADIATOR
3. The switch of the drier can be installed on either side. The important part of the
drier is that the "IN" marked on the top faces the front of the Jeep.
Step Three
Installing the Drier
Advertisement
Table of Contents
