Table of Contents
Advertisement
IMPORTANT INFORMATION
ABOUT THE INSTALLATION FOR THE CJ A/C KIT
Evaporator / Blower Unit information:
Prior to installing your evaporator unit, make sure the blower motor spins without
rubbing the case. The motor gets knocked around in shipping and may move. If the
wheel is rubbing, loosen the clamp and re-center the motor.
In order to make the installation process less complex we have simplified the wiring for
this a/c system.
There are only three wires to hook up. A test light will be used to hook up one wire.
1) Wire with a fuse inline. This wire hooks into an ignition source, a hot wire with
the key on. Use the test light to find this source.
2) Wire with an inline plug. The inline plug goes to the switch on the drier, from the
plug in the drier to the compressor. DON'T HOOK THIS UP UNTIL YOU
CHARGE THE SYSTEM.
3) Ground wire, there will be one wire on the blower motor that is not plugged in.
Ground this wire to the chassis. (Normally Yellow or Red)
Wiring information:
Advertisement
Table of Contents
