Table of Contents
Advertisement
6. Pull the carpet back on the passenger side and locate the area for the hoses to go
through the firewall. The holes will have to be drilled with a 1.25" hole saw. The
center of the first hole will be two inches under the heater box and two inches two
the right of the transmission tunnel curve. The second hole will be two inches to
the right of the first hole.
7. Insert the two rubber grommets at this time. Lube may be needed to feed the
larger a/c line through the grommet.
8. Attach the drain tube to the evaporator unit. A 5/8 "will have to be drilled into
the floor to the left of the first grommet. Put some tape around the drain tube at
the point it goes through the floor, this will help to not severe the tube, from
rubbing on the bare metal. BE SURE NOT TO DAMAGE THE
TRANSMISSION.
Advertisement
Table of Contents
