Makita HR2641 Technical Information page 19

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Swash bearing 10, Inner housing section (cont.)
ASSEMBLING
(7) Assemble Gear housing complete to Inner housing complete carefully in vertical direction as drawn in Fig. 31.
Fig. 31
Lock plate is easily fallen off from Gear housing
complete as drawn below, and therefore, support
Lock plate by finger through the hole of
Change lever insertion as the right picture.
Lock plate
(8) Assemble Armature to Motor housing. Refer to Fig. 9 of page 9.
(9) Assemble Change lever as drawn in Fig. 6 of page 7.
(10) Assemble Bit holder section. Refer to Fig. 4 of page 6.
Hold Lock plate by finger
through the hole of Change lever.
hole of Change
lever insertion.
Change plate
Be careful not to touch the edge of
Gear housing complete with Change plates.
Otherwise, they will be easily fallen off
from Clutch cam.
P 19/ 25