OSO Slimline-RI 150 Manual page 3

Safety instructions
• Read the following safety instructions
carefully before installing, maintaining or
adjusting the water heater.
• Personal injury or material damage may
result if the product is not installed or
used in the intended manner.
• Keep this manual and other relevant doc-
Safety instructions for users
The overflow from the safety valve must NOT be sealed or plugged.
The product must NOT be covered over the cover on the front.
The product must NOT be modified or changed from its original state.
Children must NOT play with the product or go near it without supervision.
!
The product should be filled with water before the power is switched on.
Maintenance/settings should only be carried out by persons over 18 years of age, with
!
sufficient understanding
The product must not be exposed to frost, over-pressure, over-voltage or chlorine treat-
ment. See warranty provisions.
Maintenance/settings should not be carried out by persons of diminished physical or
mental capacity, unless they have been instructed in the correct use by someone respon-
sible for their safety.
Safety instructions for installers
The overflow from the safety valve must NOT be sealed or plugged.
!
Discharge must comply with current building regulations.
Fixed electric fittings should be used for installation in new homes or when changing an
!
existing electrical setup in accordance with regulations.
!
The mains cable should withstand 90°C. A strain reliever must be fitted.
!
The product should be filled with water before the power is switched on.
!
The relevant regulations and standards, and this installation manual, must be followed.
The cylinder must be installed complying with current building regulations. Liability for
!
consequential damage will only apply if this is followed.
The product should be properly aligned vertically and horizontally, on a floor or wall suit-
!
able for the total weight of the product when in operation. See type plate.
The product must have a clearance for servicing of 40 cm in front of the cover / over the
!
mixer valve.
This OSO product is approved to building and water regulations by KIWA Watertec Ltd.
Tel: 01495 308 185 • Email: watertecenquiries@kiwa.co.uk
uments where they are accessible for fu-
ture reference.
• The manufacturer assumes compliance
(by the end-user) with the safety, oper-
ating and maintenance instructions sup-
plied and (by the installer) with the fitting
manual and relevant standards and regu-
lations in effect at the date of installation.
! WARNING
! CAUTION
! WARNING
! CAUTION
3