Bestop 51256 Installation Instructions

Adapter bracket for trailmax front seats for jeep wranglers

Table of Contents

Download this manual

For: Jeep

Jeep

is a registered trademark of Chrysler and

Bestop is not affiliated with Chrysler Corporation.

WARNING

Before you begin installing this seat, please read all installa-

tion instructions and warnings thoroughly.

This seat is designed to be used on the model vehicles

described above. Use of this seat on any other vehicle or

failure to install this seat properly may result in an improperly

mounted seat and could result in unexpected movement of

the seat and loss of control of the vehicle, thereby placing the

occupants of the vehicle and others in a potentially danger-

ous situation.

This seat system is intended to be used with seat belts at all

times. Do not rely on the seat to maintain the seating position

of occupants, in the event of an accident.

WEAR SEAT BELTS AT ALL TIMES

Read and follow, precisely, all installation instructions pro-

vided when installing this product. Failure to do so may result

in a poor fit and could place occupants of the vehicle in a

potentially dangerous situation.

51256 pg 1

Adapter Bracket for TrailMax™

Front Seats

Installation Instructions

Wranglers 1997 and Newer

Part Number: 51256

0300 Rev. A

Table of Contents

Need help?

Do you have a question about the 51256 and is the answer not in the manual?

Page 1 Part Number: 51256 Jeep ® is a registered trademark of Chrysler and Bestop is not affiliated with Chrysler Corporation. WARNING Before you begin installing this seat, please read all installa- tion instructions and warnings thoroughly. This seat is designed to be used on the model vehicles described above.
Page 2 Part Number: 51256 Jeep ® is a registered trademark of Chrysler and Bestop is not affiliated with Chrysler Corporation. WARNING Before you begin installing this seat, please read all installa- tion instructions and warnings thoroughly. 13 MM Box End Wrench This seat is designed to be used on the model vehicles described above.
Page 3 Install two (2) of the M8-1.25x25 Bolts that came with the seat in the bracket. Your new Bestop seat has two (2) mounting holes on each side of the front and three (3) holes on each side Place the front bracket on the seat bottom so that the holes in the of the rear.
Page 4 Adapter Bracket Adapter Bracket Seat Riser Note: In order to tumble the seat forward to access the rear of the vehicle, reach under the seat and manually push down on the Seat Release Lever. 0300 Rev. A 51256 pg 4...
Page 5 WARNING Care of your Bestop Seat Never adjust the driver’s seat or seat back when the vehicle Your seat is made of the finest materials available. To keep it looking new and for the is moving. You could loose control of the vehicle and injure maximum possible wear, it will need periodic cleaning.