Table of Contents
Advertisement
Manual for Tire Pressure Monitoring System, TPMS
Wireless Transmitter Sensor Installation
F
Step
Use a jack to raise the vehicle and place jack stands
underneath the vehicle for safety. Refer to vehicle owner's
1
manual for full service advice. Seek the assistance of a
qualified motor mechanic if required.
Take off the tires and bleed the air. Then take off the air
valve of the tire from the wheel.
2
the valve to TPMS
normally require the service of a tire fitting service or
mechanic.
Recognize the number on each sensor (D) with position of
tire on the vehicle. (VERY IMPORTANT)
a. RF – 1
3
b. RR – 2
c. LR – 3
d. LF – 4
Set up the new TPMS special valve (E) in the wheel.
4
Use wrench to fix the valve, and then tighten nut to
40~45kgf-cm (4~4.5Nm).
Use the new TPMS special Nylok screw (F) to tighten the
5
transmitter sensor into the valve on the wheel.
Torgue value must be 40~45kgf-cm (4~4.5Nm).
D
Operation Process
(NOTE: You must change
valve). This part of the process will
= Right Front, No. 1
= Right Rear, No. 2
= Left Rear, No. 3
= Left Front, No. 4
5/21
E
Photograph
Advertisement
Table of Contents
