Carax HUD CRX-3001 Quick Start Manual

HUD CRX-3001
Function buttons
Projection panel
Power/
Signal input connector
Connect Signal/Power Cable
Red wire
+ DC12V
Black wire
White wire
External
connecting
Push down
Original wire
Connect Power/Signal Cable
＊Vehicle speed display
＊5 ranges speeding warning
Light source
detect sensor
Speaker
1. Please connect the Red wire to
the DC12V power wire behind
the power-on switch.
Black wire should be connected
to ground wire.
White wire should be connected
to speed signal wire.
2. Wire clips are recommended
while connecting.
(as shown in the following figure)
wire
(Use pliers to press the sheetmetal and clip.)
Schematic illustration of
the usage of Wire Clips.
After complete wire connecting,
connect the Power/Signal Cable to
HUD.
Turn on the vehicle power, and all
function indicators will light up for
about 2 sec. This process is
checking
through the LED segments, then it
will enter the function mode of
displaying the speed of the vehicle.
Package contents
HUD main device x 1
Power/Signal Cable 1.8m x 1
Adhesive Band x 2
Place the HUD
Screen functions
Speeding warning sign(Red)
Speeding warning sound(Orange)
Function mode light(Orange)
Projection Sticker Tape x 1
Wire Clip x 3
Manual x 1
1. It's recommended to
attach the Adhesive
Bands on two sides at
the bottom of the HUD.
2. Place the HUD in a
suitable location for
clearly projecting the
vehicle speed on the
windshield.
Attach the Projection Sticker Tape
on the windshield.
Clean the windshield and spray
some water on it.
Detach the Projection Sticker,
attach it on the inner of the
windshield and scrape the
redundant water.
Function buttons
Mode Selection button
Number Up/Down button
Exit/Mute button