Reset For Tire Changes And Rotation - Carax TPMS CRX-1001 Manual

Manual for Tire Pressure Monitoring System, TPMS
When it lasts 20 minutes above that wireless receiver
couldn't receive one of the signal from wireless transmitter
5
sensor, the display will show E2; E1 indicates all wireless
transmitter sensor not receivable.

Reset for Tire Changes and Rotation

The rotation is necessary to prolong the life of your tires. The system requires resetting the tire
position to ensure the transmitter sensor can indicate the right position of your tires on display
unit. TPMS provides three modes of tire rotation methods and one mode for random
repositioning and single sensor replacement.
Mode 1: Front to Rear tires exchanged
Mode 2: Tires diagonal exchanged
Mode 3: Front tires diagonal exchanged, and Rear tires parallel exchanged to Front.
Mode 4: Random tire repositioning
Mode 5: Single sensor replaced
No.1 → Front-right tire
No.2 → Rear-right tire
No.3 → Rear-left tire
No.4 → Front-left tire
Warming
1.Do not turn off the vehicles power during this process. Doing so will immediately
interrupt the repositioning setup process. The ignition can either be in the on or start
position.
2.After repositioning, check the display is detecting all tire pressures correctly. If the
system cannot work normally, please reset it and follow the instructions again.
No.4
No.3
11/21
No.1
No.2