Mode 5: Single Sensor Replaced - Carax TPMS CRX-1001 Manual

Manual for Tire Pressure Monitoring System, TPMS
Repeat the 3-2 step above for tire No.2, No.3 and No.4
System will be back to monitoring condition automatically, and
4
receiver start to receive signals of tire pressure & tire
temperature.

Mode 5: Single sensor replaced

Step
Take off the broken sensor and replace it with a new sensor.
( if you are only checking for a signal problem from Mode 4
1
instructions, there is no need to take off the sensor, start
from step 2 if this is the case)
Press both the set key (
simultaneously for 5 seconds. The display will flash green
and red, and a "beep" sound will be heard. You can release
the buttons, and the system will have entered into mode 1.
Continue to repress the function key, each time for one
2
second and each time wait for the beep until the display
shows "5", Which means that mode has been chosen and
now preparation can be made to exchange the replaced
sensor's ID position. Tire No. 1 will show a green LED,
which means to prepare for tire No. 1 set up.
3-1
After entering mode 5, the display will show "5"
3-2
Press set key (
installed, LED will show Tire No.1 / 2 / 3 / 4.
3-3
3
When Tire No.1 (RF Tire) needs to be replaced, deflate tire
No.1 under 26 psi (tire low pressure default value) and wait
for the receiver to receive the signal. When Tire No. 1
receives the signal, you will hear "beep". Then, start inflate
tire No.1, it will keep on "beep" till Tire No. 1 is completely
inflated to normal pressure. Tire No.1 LED will turn from red
to green, and return to normal operation mode. This means
that the sensor ID setting is finished.
Operation process
) and function key (
) to choose tire which new sensor
16/21
Photograph
)