Display Unit Installation - Carax TPMS CRX-1001 Manual

Manual for Tire Pressure Monitoring System, TPMS
A
1. Plug in one side of C the power cable connection into A the display located on the side.
2. Connect the power cable C into the vehicle's cigarette lighter socket for power connection.
( or cut the cigar jet and not to cut the cable more than 5cm. plug the power cable with
ACC, Positive, Negative into fuse box)
Note: Plugging the power cable with ACC, Positive, Negative into fuse box, the LED light will
turn on only when ACC is on and the LED light will be off when ACC is turned off.
3. Install the display unit in front of driver at an appropriate position.
Stick the Velcro B into the bottom of the display unit A, and Stick the unit into the
convenient place.
4. After set up the monitor please take off the protection film from the panel of monitor.
B A
C
D
C

Display Unit Installation

Plug into car power socket
4/21
B
H
Positive (Red)
ACC
(Green)
F
E
Antenna (black)
Negative (spiral shield)
Power Cable