Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Analytic Systems VTC605 Series
Summary of Contents for Analytic Systems VTC605 Series
- Page 1 INSTALLATION & OPERATION MANUAL VTC605 SERIES VOLTAGE CONVERTER...
- Page 2 6. Never allow battery acid to drip on the voltage converter. Medical Equipment Notice Analytic Systems does not recommend the use of their products in life support applications where failure or malfunction of this product can be reasonably expected to cause failure of the life support device or to significantly affect its safety or effectiveness.
- Page 3 TABLE OF CONTENTS • Front Cover, Product Photo and Title • Product warnings and advisories • Table of Contents • Description/Overview of product • Main Parts • Operation instructions • Mounting Instructions • Connection instructions • Configuration instructions • Options •...
-
Page 4: Main Parts
Introduction Step up a 12 VDC battery to between 13.5 and 17.0 or 24.0 and 27.5 VDC in 0.5 VDC increments (via 3 position DIP switch), or stabilize a 12 or 24 VDC power system. Safety features include reverse input protection, low input voltage alarm, low output voltage alarm, over temperature shutdown and alarm, and output overvoltage crowbar. - Page 5 Right Side of Chassis 1. Ground Stud 2. Input Fuses (2x) 3. Input Wires, 2x Positive and 2x Negative Top of Chassis 1. Indicator LEDs 2. Output Voltage Adjust DIP Switches...
-
Page 6: Operation
Operation To turn the unit on, simply press the Power push button. The alarm buzzer will sound and the Low Output LED will come on briefly, and then the green OUTPUT ON LED will illuminate. The unit will provide the regulated voltage from no load to the maximum load shown in the specifications section. -
Page 7: Remote Control
IMPORTANT: This remote is to be used only with Voltage Converters manufactured by Analytic Systems REMOTE CONNECTOR This connector is located on the left side of the unit. Important: The function of each pin is shown in the table, and the location of each pin in the connector in the diagram below. -
Page 8: Installation
Installation Mounting Mount the unit and allow at least 1 inch of clearance around the heat sink fins for adequate cooling. 4.25 Input Connection 2.50 This unit is equipped with 2 pairs of AWG10 0.20 6.18 input leads approximately 1.0 meter in length 7.75 9.06 for connection to the DC power source rated... -
Page 9: Troubleshooting
Troubleshooting This unit provides LED indicators and a buzzer to help diagnose any problems. The unit should sound the buzzer to alert you prior to shutting itself down. You should immediately check the indicators to determine the cause of the shutdown. OVERLOAD Indicates that the load connected to the voltage converter exceeds the continuous rating. -
Page 10: Specifications
Specifications Input Voltages Input Volts Actual 10.5 - 14.0 VDC 21 - 28 VDC Input Amps 50 Amps Max Input Fuse - 1/4 x 1 1/4 2 x AGC 30 Amps in parallel Noise on Input < 50 mV Output Voltages Output Volts Actual (Input –... -
Page 11: Limited Warranty
2 Years from date of manufacture for non-standard or OEM products 1 Year from date of manufacture for encapsulated products. 3. Analytic Systems will determine eligibility for warranty from the date of purchase shown on the warranty card when returned within 30 days, or...
Need help?
Do you have a question about the VTC605 Series and is the answer not in the manual?
Questions and answers