Restoring The Default Settings For An Aggregate Interface - H3C S6850 Series Configuration Manual

Procedure
1. Enter system view.
system-view
2. Enter aggregate interface view.
Enter Layer 2 aggregate interface view.
interface bridge-aggregation interface-number
Enter Layer 3 aggregate interface view.
interface route-aggregation interface-number
Enter Layer 3 aggregate subinterface view.
interface route-aggregation interface-number.subnumber }
3. Shut down the interface.
shutdown

Restoring the default settings for an aggregate interface

Restrictions and guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of
the impacts of this command when you execute it on a live network.
The default command might fail to restore the default settings for some commands for reasons
such as command dependencies and system restrictions.
To resolve this issue:
1. Use the display this command in interface view to identify these commands.
2. Use their undo forms or follow the command reference to restore their default settings.
3. If the restoration attempt still fails, follow the error message instructions to resolve the issue.
Procedure
1. Enter system view.
system-view
2. Enter aggregate interface view.
Enter Layer 2 aggregate interface view.
interface bridge-aggregation interface-number
Enter Layer 3 aggregate interface view.
interface route-aggregation interface-number
Enter Layer 3 aggregate subinterface view.
interface route-aggregation interface-number.subnumber }
3. Restore the default settings for the aggregate interface.
default
21