Configuring Dr System Settings; Configuring The Dr System Mac Address; Setting The Dr System Number; Setting The Dr System Priority - H3C S6850 Series Configuration Manual

Configuring DR system settings

Configuring the DR system MAC address

Restrictions and guidelines
Changing the DR system MAC address causes DR system split. When you perform this task on a
live network, make sure you are fully aware of its impact.
The DR system MAC address uniquely identifies the DR system on the network. For the DR member
devices to be identified as one DR system, you must configure the same DR system MAC address
on them. As a best practice, use the bridge MAC address of one DR member device as the DR
system MAC address.
Procedure
1. Enter system view.
system-view
2. Configure the DR system MAC address.
drni system-mac mac-address
By default, the DR system MAC address is not configured.

Setting the DR system number

Restrictions and guidelines
Changing the DR system number causes DR system split. When you perform this task on a live
network, make sure you are fully aware of its impact.
You must assign different DR system numbers to the DR member devices in a DR system.
Procedure
1. Enter system view.
system-view
2. Set the DR system number.
drni system-number system-number
By default, the DR system number is not set.

Setting the DR system priority

About the DR system priority
A DR system uses its DR system priority as the system LACP priority to communicate with the
remote aggregation system.
Restrictions and guidelines
Changing the DR system priority causes DR system split. When you perform this task on a live
network, make sure you are fully aware of its impact.
You must configure the same DR system priority for the DR member devices in a DR system.
Procedure
1. Enter system view.
system-view
9