Display And Maintenance Commands For L2Pt; L2Pt Configuration Examples; Example: Configuring L2Pt For Stp - H3C S6850 Series Configuration Manual

Procedure
1. Enter system view.
system-view
2. Set the destination multicast MAC address for tunneled packets.
l2protocol tunnel-dmac mac-address
By default, 010f-e200-0003 is used for tunneled packets.

Display and maintenance commands for L2PT

Execute display commands in any view and reset commands in user view.
Task
Display L2PT statistics.
Clear L2PT statistics.

L2PT configuration examples

Example: Configuring L2PT for STP

Network configuration
As shown in
00e0-fc02-5802, respectively. MSTP is enabled in Customer A's network, and default MSTP
settings are used.
Perform the following tasks on the PEs:
•
Configure the ports that connect to CEs as access ports, and configure the ports in the service
provider network as trunk ports. Configure ports in the service provider network to allow
packets from any VLAN to pass.
•
Enable L2PT for STP to enable Customer A's network to implement independent spanning
tree calculation across the service provider network.
•
Set the destination multicast MAC address to 0100-0ccd-cdd0 for tunneled packets.
Figure 4 Network diagram
Figure 4, the MAC addresses of CE 1 and CE 2 are 00e0-fc02-5800 and
Command
display l2protocol statistics [ interface
interface-type interface-number ]
reset l2protocol statistics [ interface
interface-type interface-number ]
5