Table of Contents
Advertisement
Fluids: When used as a powered system, avoid spilling fluids on control unit. Fluids remaining
on controls can cause corrosion, which may cause components to fail or operate erratically,
possibly producing potential hazards for patient and staff. If spills do occur, unplug the unit
immediately and clean fluid from control unit wearing rubber gloves while it is unplugged to
avoid any possibility of shock. Once fluid is removed, check operation of components in area of
spill.
No Smoking in Bed: Smoking in bed can be dangerous. To avoid the risk of fire, smoking in
bed should never be allowed.
Disposal: At the end of useful life, dispose of waste according to local requirements.
Preparation For Use
1. Open shipping container and check for damages which may have occurred en route. DO
NOT USE SHARP INSTRUMENTS TO OPEN BOXES. DAMAGE TO MATTRESS COULD
RESULT.
2. Remove Protekt® Aire Supreme Support Self-Adjusting Air/Foam Mattress from protective
plastic cover.
The mattress may appear wrinkled when unpacked. To remove wrinkles, allow mattress up to
24 hours to accommodate; see Troubleshooting table for more information. Wrinkles will not
affect inflation or function. Mattress may be used immediately if needed
3. Check mattresses surface for tears or cracking; do not use if tears or cracking are present. If
any damages exist, please contact your local provider immediately.
4. If re-installing the Protekt® Aire Supreme Support onto a new frame or for a new patient,
check mattress surface for staining and soiling; clean and/or disinfect as required (see Care
and Cleaning section).
5. Level bed and lock brakes.
6. Remove existing mattress from bed frame.
Mattress Installation
1. Position mattress on bed frame with logo facing up and heel slope section aligned at the foot
of the bed.
2. Ensure mattress is properly positioned with no gaps between mattress and bed frame or side
rails. Always use a standard healthcare bed frame with safeguards or protocols that may be
appropriate. Frame and side rails must be properly sized relative to the mattress to help
minimize any gaps that might entrap a patient's head or body.
4
Advertisement
Table of Contents
