Advertisement
FRAME ASSEMBLY
YETI TIPS
Make sure your tools are in good condition.
A worn allen key can round the hex on a
bolt not allowing for proper torque.
Torque settings are listed throughout the
instructions and on page 10 of this manual.
It is important to prep all bolt threads. The
instructions denote whether to use a Loctite
compound or grease. Reference Exploded
View for assembly part locations listed in
parentheses.
Warning: Service on Yeti bicycles requires special
knowledge and tools. Yeti Cycles recommends that all
service and repairs be performed by an authorized Yeti
Dealer
15.
TOOLS NEEDED
• 2.5mm allen key
• 4mm allen key
• 8mm allen key
• Torque wrench
Grease 4x H20 Bolts (2.2) and
install with washers (2.1) to frame
downtube.
Torque: 4-5 Nm
Place a Double Port Clamp (2.12)
into the non-drive side cover and a
Single Port Clamp (2.11) into the
drive-side cover. Secure with M4 x
25L screws.
Tighten until snug. Hardware can be
torqued to 2-3 Nm after housing
installation.
Place a Head Tube Cable Port
Cover (2.11) into each recess
behind the head tube.
Assemble a Lower Port Clamp
(2.15) to the Down Tube Port
Cover (2.14) using a Flat Head M4
x 16L screw. Hardware can be
torqued to 2-3 Nm after housing
installation.
16.
Advertisement
