Advertisement
A S S E M B L Y
Install the Down Tube Port
Cover (2.14) into the frame
with a Flat Head M4 x 16L
screw (2.16).
Torque: 3 Nm
Apply Blue Loctite 243 to threads
of the Hanger Stop Bolt (2.5).
Install Stop Bolt into rear dropout.
Torque: 5 Nm
17.
Install the Chainstay Cable Port Cover
(2.7) to the non-drive side chainstay
port and secure with Flat Head M4 x
10L.
Hardware can be torqued to 2-3 Nm
after housing installation.
Install Universal Hanger (2.4)
into frame. Do not use grease.
Note that hanger cap bolt is
REVERSE THREADED.
Torque: 25 Nm
Note that different Port Clamps
may
be
used
for
different
configurations of shifter and
dropper seatpost.
An extra
single-port and blank cover are
provided depending on your
needs.
18
Advertisement
