291, 292, 294
Users Manual
Introduction
Pressing the UTILITY key calls a list of menus which give access to various system
operations including storing/recalling set-ups from a memory card, error messages, power
on settings and calibration.
Each of the following operations is accessed by pressing the appropriate soft key on the
UTILITY MENU. Press UTILITY again at any time to return to the main utility menu.
Channel Waveform Information
Pressing chan wfm info... calls the CHANNEL WFM INFO screen:
This screen shows the number of arbitrary waveforms currently resident in the
instrument's high speed memory and the number of free points for further waveforms.
This is useful when constructing a large sequence of many waveforms as a guide to the
spare memory remaining.
Warnings and Error Messages
The default set-up is for all warning and error messages to be displayed and for a beep to
sound with each message. This set-up can be changed on the error... menu:
Each feature can be turned ON or OFF with alternate presses of the appropriate soft-
key.
The last two error messages can be viewed by pressing the last error... soft-key.
Each message has a number and the full list appears in the appendix. See also Warnings
and Error Messages in chapter 5, Standard Waveforms.
Remote Interface Set-Up
Pressing remote... calls the REMOTE set-up screen which permits RS232, GPIB and
USB choice and the selection of address and Baud rate. Full details are given in chapter
17, Remote operation.
SYS/REF Clock In/Out and System Clock Setting
This screen allows the system clock frequencies to be set and the ARB CLOCK IN/OUT
socket to be set to input or output. There is no system clock on a single channel
instrument.
15-2
Shop for Fluke products online at:
CHANNEL WFM INFO:
waveforms: 3
free mem:
142146
exit
error beep: ON
error message: ON
warn beep: ON
warn message: ON
MyFlukeStore
www.
1.888.610.7664
.com