Troubleshooting And Storage - Weslo WCTL39102 User Manual

TROUBLESHOOTING AND STORAGE

Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies to your treadmill and follow the steps listed. If further assistance is needed, please call our
Customer Service Department toll-free at 1-888-936-4266, Monday through Friday, 8h00 until 18h30 east-
ern time (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged
into a properly grounded outlet (see page 7). Use only a CUL-listed surge suppressor, rated at 15 amps,
with a 1 mm 2 (14-gauge) cord of 1.5 m (5 ft.) or less in length.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console (see step
1 on page 8).
c. Check the circuit breaker located on the treadmill frame near
the power cord. If the switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the circuit breaker located on the treadmill frame near the power cord. If the circuit breaker has
tripped, the switch will protrude (see the drawing above). To reset the circuit breaker, wait for five minutes
and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console (see step 1 on page 8).
3. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY
a. Check the batteries in the console (see assembly step 5 on page 6). Most problems are the result of drained
batteries.
b. If the speed display does not show a correct reading, remove the
key and UNPLUG THE POWER CORD. Remove the four
screws from the sides and front of the hood. Carefully remove the
hood. Locate the Reed Switch (73) and the Magnet (75) on the
left side of the Pulley (43). Turn the Pulley until the Magnet is
aligned with the Reed Switch. Make sure that the gap between
the Magnet and the Reed Switch is about 3 mm (1/8 in.). If
necessary, loosen the Screw (53) and move the Reed Switch
slightly. Retighten the Screw. Re-attach the hood and run the
treadmill for a few minutes to check for a correct speed reading.
4. SYMPTOM: THE WALKING BELT SLOWS OR STOPS WHEN WALKED ON
a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 7.
b. Increase the incline of the treadmill (see HOW TO CHANGE THE INCLINE OF THE TREADMILL on page 9).
c. Make sure that you are using proper form when walking on the treadmill (see PROPER EXERCISE FORM
on page 6).
d. If the walking belt still slows when walked on, please call our Customer Service Department.
Tripped
b
1/8"
73
Top
View
10
Reset
75
53
43