3.
Configure the relevant values to your setup for the following:
•
Protocol Type
•
Framing Method
•
Transfer Mode
4.
After you configure the parameters, click the Apply Trunk Settings button, and then
wait for the trunk settings to be applied. Once the trunk settings are applied, the trunk
status icons at the top of the page change to green for all trunks that are connected to
the PBX.
5.
If there is more than one trunk connection between the PBX and gateway, repeat this
step for each of the trunks, or click the Apply to All Trunks button.
Configuration Note
Avaya Aura Messaging & Nortel CS1000
18
Document #: LTRT-12470