Table of Contents
Advertisement
Installation
Bend the claws
according to
the thickness
of the
dashboard
Basic Installation
Before installing, make sure that the
ignition-switch is set to OFF and remove
the terminal of the car battery to avoid
short-circuiting.
a Remove the existing receiver unit.
b Make the necessary connections.
c Install the installation sleeve.
d Install the unit in to the installation sleeve.
Removing existing receiver unit
If there is already an installation sleeve
for the receiver unit in the dashboard, it
must be removed.
1
4
3
5
6
ISO-DIN Installation
a Slide radio into ISO-DIN frame.
b Install screws removed from old
radio.
c Slide radio and frame into dash
opening.
d Install dash panel or adapter plate.
e Install trim ring to radio. The notch on
trim ring must be positioned at the
bottom.
f Install faceplate by fitting right edge
into position then pushing left edge
closed.
6
2
When removing the unit from the
installation sleeve
If you need to remove the unit from the
installation sleeve, proceed as follows.
a Remove the rear supporter from the unit.
b Remove the front panel from the unit.
c Insert the lever into hole on one side
of the unit,and pull the lever toward
you. Do the same operation on the
other side and pull out the unit from
the installation sleeve.
Advertisement
Table of Contents
