Table of Contents
Advertisement
Reference Manual
00809-0100-4856 Rev AE
February 2020
4. Continue to press the metal base onto the lamellar insert until it
stops at the end position. Push the sealing ring into the lamellar
insert as shown.
5. While using one of the 22 mm open-end wrenches to keep the
metal base steady, screw the dome nut onto the metal base until
finger tight. Then use the second 22 mm open-end wrench to
tighten the dome nut an additional half turn. Ensure that the
metal base is held steady during this entire step to prevent
damage to the metal braiding on the cable.
Rosemount 356
A-7
Advertisement
Table of Contents
