Check The Condition Of The Battery.; Check The Product Operates Correctly.; Check The Barking Detection Sensitivity Adjustment. - Num'axes IKI Voice Technical Support

Check the condition of the battery.

When the battery is too weak for the operation of the product, beep sounds indicate it in 2 cases:
− when switching on the collar: a series of close beep sounds + number of beep sounds meant to
indicate the operating mode are emitted.
− when switching off the collar: a series of close beep sounds is emitted.
Replace the weak battery with a new one of the same type (lithium 3-V CR2450) paying attention to
follow polarity indicated on the battery housing.
Due to greater use during your dog's training, the first battery may not last as long as replacement
batteries.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brand of batteries may not operate, or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.

Check the product operates correctly.

When leaving the factory, the collar is set on mode 2 "beep sounds + recorded messages".
3 operating modes are available on each collar (see paragraph "Change the operating mode" below).
Check the collar is operating properly at any time using the following procedure:
− Switch on the collar using the magnetic key.
− Slowly rub the sensor on a slightly rough surface (change the barking detection sensitivity if
necessary).
− In mode 1 "vibrations + beep sounds", the collar must vibrate and emit beep sounds.
− In mode 2 "beep sounds + recorded messages", the collar must emit beep sounds and vocal
messages.
− In mode 3 "vibrations + recorded messages", the collar must vibrate and emit vocal messages.
NOTE: after being activated 3 times in quick succession, the collar will automatically go into safety mode
for 15 seconds, before restarting normally.

Check the barking detection sensitivity adjustment.

Setting the barking detection sensitivity is a very important operation. In fact, this setting determines
the correct operation of the collar. It ensures detection of any barking but helps avoid unnecessary
triggering.
The detection must therefore be sufficiently sensitive but not overly sensitive.
When leaving the factory, detection sensitivity is set on the maximum position (maximum sensitivity).
To adapt the barking detection to the barking strength of your dog, you should proceed as follows:
− Remove the 2 screws from the battery cover.
IKI Voice technical support www.numaxes.com maj 07/2020 - 2/5