Functional Overview; Front Panel - Marantz ZS5300 User Manual

Functional Overview
I Front panel
6
~~""'''.roHE5B.ECTORI~
5
4
o
~II--~I
1 2
3
CD
Main power switch (POWER ON
I
STANDBY)
Press this button to turn the main power on. Press again
to turn it off. When the main power is turned on, Zonei,
Zone2 and Zone3 turn into standby mode and power for
each zone can be switched with the remote control unit
RC5300ZS (provided) or a Keypad (option). For regular
use, please leave the unit powered on.
®
Volume level indicator (LEVEL)
These indicators show the level of the volume. When all
the indicators light up, the volume is at the maximum level.
When all the indicators lights are off, the volume is at the
minimum level. Volume can be adjusted individually from
each of Zonei, Zone2 and Zone3. Volume adjustment can
be adjusted, with the remote control unit or a Keypad.
Mute indicator (MUTE)
These indicators flash when the sound is muted. When
volume is at the maximum, all the indicators flash. When
the volume is at the minimum, only the first indicator
flashes. Mute can be controlled individually from each of
Zonei, Zone2 and Zone3. Muting can be done with the
remote control unit or a Keypad. If the volume is adjusted
when muted, mute is released.
Caution
When these indicators are flashing, no sound is outputted.
When releasing mute, please check the volume position. If
volume is set too loud, the speakers may be damaged.
4
@
Standby indicator (STANDBY)
This indicator lights up when any of the zones are in
standby. Zone 1, Zone2 and Zone3 can be in standby
mode independently. Power for each zone can be
controlled with the remote control unit or a Keypad.
@)
Direct indicator (DIRECT)
When the "Zone Direct" input is chosen for the source, this
indicator lights up. The source connected to the "Zone
Direct" terminal for Zonei can be selected only for Zonei.
The same applies for Zone2 and Zone3. Source selection
can be selected with the remote control unit or a Keypad.
@
Input-indicator (INPUT)
Depending on which input is selected in each zone, the
appropriate INPUT indicator will be illuminated. The Inputs
can be selected by a remote control unit or a Keypad.
®
IR (Remote contrOl) sensor
This window receives infrared signals from the remote
control unit.