Frequently Asked Questions - MIMAKI JV300-130 BS INK Print Manual

Please prepare before use.
Before printing, the preparation for the printer and the software RIP [RasterLink] is required.
About system configuration. (Refer to P. 3)
The explanation of the system configuration to print is described.
Prepare the printer. (Refer to P. 4)
This section explains how to prepare the printer.
 Connecting a PC installed RasterLink to the printer.
 Adjusting the head height.
 Set the media.
 Test print
 Feed rate corrction (Media correction)
 Ink drop position correction（Dot position correction）
Prepare the Mimaki Driver. (Refer to P. 5)
Install Mimaki Driver.
Prepare the RasterLink. (Refer to P. 5)
The preparation of RasterLink is explained.
For the installation method, refer to the "Installation Guide" of the RasterLink.
The printing method using a sample is
explained.
For JV300-130/160 BS INK MODEL: Prepare any image data, or sample images on the attached CD.
For JV300-130/160 Plus BS INK MODEL: Prepare any image data.
Perform printing. (Refer to P. 7)
Download the profile suitable for the using condition. (Refer to P. 9)

Frequently asked questions.

Typical questions. (Refer to P. 11)
- 2 -