Page Setup - SATO FX3-LX Driver Manual

Hide thumbs Also See for FX3-LX:

Table of Contents

4.1

Page Setup

[Stock]

Select the default stock from the registered stock. If you select [Custom], you can set [Width],

[Height], and [Sensors] on this screen.

[Custom stock has ID 257]

This check box enables compatibility with older SATO drivers that require a custom stock ID of

greater than 256.

[Copies]

Specify the number of labels to be issued.

[Width]

This setting shows the width set for the stock that you selected. If you select [Custom] for [Stock],

you can change the settings on this screen.

[Height]

This setting shows the height set for the stock that you selected. If you select [Custom] for

[Stock], you can change the settings on this screen.

[Media type]

This setting shows the sensor set for the stock that you selected. If you select [Custom] for

[Stock], you can change the settings on this screen. You can select [Continuous labels], [Labels

with gaps], or [Labels with black marks].

[Black mark position]

You can set the media type. This setting can only be configured when [Media type] is set to

[Labels with black marks]. Select from [Bottom black mark] and [Top black mark].

Table of Contents