Table of Contents
Advertisement
INSTALLATION
To install your DSL LAN Extender 400 devices, you need to use the following cable connection for each
device:
•
Supplied DC power adapter
•
10BaseT Ethernet cable
•
DSL telephone cable
•
Serial cable – you only need to connect a serial cable if you want to configure the DSL LAN
Extender device via a serial port connection.
•
Please see the section below for Port Pin Layout of Console (RS-232), 10BaseT, and DSL LINE
ports.
The illustration below shows the ports on the DSL LAN Extender 400's rear panel to which you connect
the cables.
1.
Connections
(1) DC power adapter terminal. Connect this terminal with the power jack from the supplied DC power
adapter.
(2) LAN Network Port: Standard 10BaseT Ethernet interface port (RJ-45 Jack).
(3) Console Port, RS-232 (DB9 Female Connector): Console serial port for system configuration.
(4) xDSL Line Interface: Standard RJ-11 Jack (using Pins 3 and 4).
2.
© 2002 Black Box Corporation
DSL LAN Extender 400 User's Guide
3.
4.
Page 4
Advertisement
Table of Contents
