Installation; Tools Required; Before You Start; General Set-Up - Black Box CityLIGHT LCL533A Manual

NOTE: The CityLIGHT 10/100 Ethernet Transceiver is hot-swappable; the
power to the CityLIGHT 1U or 3U Chassis and the CityLIGHT 2-Card
Chassis does not need to be turned off during installation or removal.

3.1 Tools Required

To install the CityLIGHT Fiber Extender Module, the following items are required:
Flat-bladed Screwdriver
Fiber Cleaning Kit
Fiber Patch Cords
Electrical Patch Cables
Loss Set (Power Meter and 1300 nm Light Source)

3.2 Before You Start

Make sure that both CityLIGHT chassis (local and remote) are correctly installed.
Make sure you have the following information before you start:
Cable Type: 100Ω Category 5 RJ 45.
Fiber Connection: Check that the connections on the units, the patch cords used,
and the site requirement are compatible.
As the CityLIGHT 10/100 Ethernet Transceiver is a long-distance product,
installation is greatly simplified with a technician at each end of the link. This
allows link tests to be completed in the minimum of time.

3.3 General Set-Up

1) Set switch 1 to the required operating speed; OFF for 10 Mbps or ON for
100 Mbps operation on both CityLIGHT Fiber Extender Modules.
CITYLIGHT 10/100 ETHERNET TRANSCEIVER CARD

3. INSTALLATION

17