Table of Contents
Advertisement
Network Mode Configuration - Local (CO) Side
===== Network Mode Configuration =====
. Device Serves at Side
. Router Enabled
. Bridging Enabled
. RIP Enabled
. Device Main IP Address
. Device Main IP Subnet Mask
. Ethernet Side Default Gateway
. Bandwidth Limit, Outbound(Kbit/s):
. Bandwidth Limit, Inbound(Kbit/s) :
Ctrl-s
Press Esc to return to the main menu
Network Mode Configuration – Remote (CP) Side
===== Network Mode Configuration =====
. Device Serves at Side
. Router Enabled
. Bridging Enabled
. RIP Enabled
. Device Main IP Address
. Device Main IP Subnet Mask
. Ethernet Side Default Gateway
. NAT/Router Enabled
(Items below have no effect unless NAT/Router is enabled)
. Subscriber IP Address
. Subscriber Subnet Mask
. E-mail Server Enabled
. E-mail Server's IP Address
. HTTP/FTP Server's IP Address
Ctrl-s
Press Esc to return to the main menu
By default, the DSL LAN Extender CO and CP devices are pre-assigned the same IP address at the
factory: 192.168.100.1. You should assign the DSL LAN Extender device a valid host IP address in the
same sub-network as the Ethernet to which it is directly connected.
To configure the DSL LAN Extender without using a serial port, please see Appendix D.
Save all
:
:
:
:
:
:
:
:
:
:
: N
: 255.255.255.
:
Save all
© 2002 Black Box Corporation
DSL LAN Extender 400 User's Guide
: CO
: N
: Y
: N
: 192.168.100.
1
: 255.255.255.
0
:
0.
0.
0.
0
0
0
CP
N
Y
N
192.168.100.
1
255.255.255.
0
0.
0.
0.
0
N
0.
0.
0.
0
0.
0.
0.
0
0
0.
0.
0.
0
Page 12
Advertisement
Table of Contents
