Main Menu; System Information - Black Box DSL LAN Extender 400 User Manual

Main Menu

After entering the correct password, the following message is displayed. Select the desired function by
entering the corresponding number.
Copyright (C) 2002, Black Box Corporation, Inc.
Main Menu

1. System Information

2. Traffic Statistics
3. DSL Status/Configuration
4. Network Mode Configuration
5. DHCP Status/Configuration
6. SNMP Configuration
7. MAC Address Filter
8. Password Change
9. Software Upgrade
A. System Reboot
B. Set Factory Default
0. Exit
Make A Choice :
Tab
Up/down Arrow
Left/right Arrow: Move cursor by one character
Space/enter
Ctrl-S
Esc
System Information
- System Name: This allows the user to give the DSL LAN Extender a System Name.
- Security Level: This permits the user to set the security level to high or low by pressing <Enter>. If
security level is set to "High", the Main Menu cannot be accessed without the correct password.
- Allow TFTP Download: This allows the user to enable or disable software upgrades through TFTP.
- The Device Configured as: This indicates if the device is configured as a CO (Central Office or
Central Unit) or a CP (Customer Premise or Remote Unit) device.
- The next four lines display the currently assigned MAC Address, Device Main IP Address, Controller
Serial No., and Controller HW Version respectively.
- Software Version: This indicates the current software version of the.
- Software Checksum: You should record this checksum and compare it with the displayed one every
time the device is reset or power-cycled. This checksum should be the same; if it changes, the
device's software has been corrupted. In this case you will have to reload the software. Please note
that each new software version has a different checksum.
: Move to next changeable field
: Move cursor by one line
: Next choice when in selection field
: Save all changes of current screen
: Leave current table or screen
© 2002 Black Box Corporation
DSL LAN Extender 400 User's Guide
Page 9