Weider WESY37530 User Manual page 16

35. Route the Low Cable (63) through the Leg Lever
(18), around a 90mm Pulley (38), and back
through the Leg Lever and Left Leg (8). Attach the
Pulley inside the Leg Lever with an M10 x 67mm
Bolt (88), two M10 Washers (74), two 12mm
Spacers (57), and an M10 Nylon Locknut (75).
36. Wrap the Low Cable (63) under a 90mm Pulley
(38). Attach the Pulley to the Left Base (2) with an
M10 x 45mm Bolt (78) and an M10 Nylon Locknut
(75).
37. Wrap the Low Cable (63) under a 90mm Pulley
(38). Attach the Pulley and a Cable Trap (37) to
the indicated bracket on the Left Base (2) with an
M10 x 48mm Bolt (23) and an M10 Nylon Locknut
(75). Make sure the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
38. Wrap the Low Cable (63) over a "V"-pulley (40).
Attach the "V"-pulley and a Large Cable Trap (39)
to the bracket on the Left Upright (6) with an M10
x 60mm Bolt (82) and an M10 Nylon Locknut (75).
Make sure that the Cable Trap is turned to hold
the Cable in the groove of the "V"-pulley.
35
57
74
88
36
38
78
37
2
23
38
75
16
18
75
57
8
74
38
63
63
75
2
75
37
38
63
82
39
40
63
6