Weider WESY37530 User Manual page 15

31. Route the Short Cable (62) over a 90mm Pulley
(38). Attach the Pulley to the front bracket on the
Right Top Frame (10) with an M10 x 45mm Bolt
(78) and an M10 Nylon Locknut (75).
32. Thread an M12 Nut (80) onto the Short Cable
(62) as far as it will go. Slide a 50mm Washer
(59) onto the Cable and thread the Cable into the
Weight Tube (34) until the Cable is tight. Tighten
the Nut against the Washer.
33. Locate the Low Cable (63). Route the Cable
under a 90mm Pulley (38). Attach the Pulley
inside the bracket on the Left Base (2) with an
M10 x 45mm Bolt (78) and an M10 Nylon Locknut
(75).
34. Wrap the Low Cable (63) around a 90mm Pulley
(38). Attach the Pulley inside the Left Leg (8) with
an M10 x 78mm Bolt (86), two M10 Washers
(74), two 17mm spacers (58), and an M10 Nylon
Locknut (75).
31
32
62
80
59
33
2
34
74
58
86
15
10
Front
Bracket
75
78
38
62
34
38
75
78
63
74
8
75
58
63
38