Converting From The Floorstand Model To The Rack Model - Fujitsu PRIMERGY TX150 S4 Options Manual

11 Converting from the floorstand
model to the rack model
V
CAUTION!
Observe the safety instructions in the
et seqq..
Ê Open the server and remove the front cover as described in the
"Preparation" on page
I
The front cover is no longer required.
Figure 40: Removing the anti-tilt bracket
Ê If your server is equipped with an anti-tilt bracket, remove it:
Ê Remove the two knurled screws (1) and lift the server out of the anti-tilt
bracket.
U41629-J-Z156-2-76
19ff.
Options Guide
chapter "Safety notes" on page 13
chapter
61