Weider WEBE08900 User Manual page 9

10. Attach the Backrest (15) to the Backrest Tubes (20)
using four M6 x 38mm Screws (14) and four M6
Flat Washers (51).
Make sure that the Backrest (15) is oriented so
that there is a gap between the Backrest and the
Seat (16).
11. Press a 1Ó Round Inner Cap (21) into the weight
tube of the Weight Carriage (12). Slide a Weight
Stop (34) onto the weight tube. Press a 2 1/2Ó
Square Bushing (23) onto each end of the Weight
Carriage (12).
Slide an M10 x 19mm Bolt (44) into the bracket on
the Weight Carriage (12). Slide the Weight Carriage
onto the Lat Tower (11).
Thread the Cable (25) through the slot of the Lat
Tower (11) in the direction indicated. Connect the
end of the Cable without the ball to the Weight
Carriage (12) using the M10 x 19mm Bolt (44) and
an M10 Nylon Locknut (45).
12. Press a 45mm Square Inner Cap (28) into the top
of the Lat Tower (11). Route the Cable (25) around
the Pulley (26) as indicated. Slide the Pulley into
the slot of the Lat Tower and attach it with an M10 x
64mm Bolt (46), two M10 Flat Washers (54), two
M10 Spacers (42), and an M10 Nylon Locknut (45).
Do not overtighten the Nylon Locknut. The
Pulley must be able to turn freely. Attach the
Cable Clip (35) to the end of the Cable.
13. Slide the Lat Tower (11) into the Front Leg (2).
Tighten it in place with the Short Adjustment Knob
(27).
10
15
16
11
Slot
Weight
Tube
45
21
34
12
54
45
26
13
11
2
9
14 51
20
51
14
Ball
11
23
25
44
Bracket
12
23
28
42
42
54
46
25
11
35
27