Seat Assembly - Weider Pro 4950 831.14623.0 User Manual

54. Wrap the Leg Lever Cable (51) around a "V"-
pulley (47). Attach the Pulley to the Right
Upright (2) with an M10 x 68mm Bolt (85), two
Half Guards (55), an M10 Washer (80), a Long
Cable Trap (57), and an M10 Nylon Locknut
(77). Make sure the Cable Trap and Half
Guards are oriented as shown.
55. Wrap the Leg Lever Cable (51) under a 90mm
Pulley (48). Attach the Pulley and a Cable Trap
(56) to the Left Press Arm (15) with an M10 x
50mm Bolt (97), two Half Guards (55), an M10
Washer (80), and an M10 Nylon Locknut (77).
Make sure the Cable Trap and Half Guards
are oriented as shown.
56. Remove the indicated M10 Nylon Locknut (77).
Attach the Leg Lever Cable (51) to the Right
Upright (2) with the M10 x 120mm Bolt (115),
an M10 Washer (80), a 7mm Spacer (111), and
the M10 Nylon Locknut.

Seat Assembly

57. Attach a Backrest (31) to the Right Backrest
Frame (7) with two M6 x 16mm Screws (88), an
M6 x 32mm Screw (89), and an M6 Washer
(114).
Insert the Right Backrest Frame (7) into the
Right Upright (2) and tighten a Backrest
Adjustment Knob (53) into the Upright. Make
sure the Adjustment Knob passes through
one of the holes in the Backrest Frame.
Repeat this step for the Left Backrest Frame
(3, not shown).
54
51
55
56
57
31
24
2
55
57
77
47
80
55
85
97
51
56
55
15 80
48
55
2
115
80
111
77
51
2
88
53
7
89
114
77