Download Print this page

Sealey POWERSTART200 Instructions page 4

Portable jump start units

Advertisement

5.13.
After use, immediately recharge the PoWErstArt as described in 4.2.
WarninG! BEFORE CHARGING THIS UNIT, DISCONNECT THE OUTPUT LEADS FROM THE UNIT AS THEY WILL REMAIN "LIVE"
WHILE CHARGING.
WarninG! NEVER CLAMP THE OUTPUT LEADS TO THE CARRY HANDLE AS THIS COULD RESULT IN SHORT CIRCUIT.
WarninG! the warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that
may occur. it must be understood that common sense and caution are factors which cannot be built into this product, but must be applied
by the operator.
5.14.
on poWerstart500.V2 and 900 models, the negative blaCK clamp is fitted with a 500a fuse within the black sleeve. (fig.3A).
Before accessing this fuse, turn the switch knob to off and unplug the power leads from the unit. Work the black sleeve down into the
black lead. see fig.3B. After replacing the fuse ensure the black sleeve fully covers the clamp.
6. TROUBLESHOOTING
Question:
can the PoWErstArt be recycled?
What is the ideal in-use storage temperature of the
PoWErstArt?
i have a regular battery charger, can i use it to recharge the
PoWErstArt?
is the PoWErstArt fool proof?
can the PoWErstArt battery(ies) be replaced?
can the PoWErstArt be used continuously?
Powerstart will not work even when the electronic trip
has been reset.
enVironment proteCtion
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, Kempson Way, suffolk business park, bury st edmunds, suffolk. ip32 7ar
01284 757500
© Jack Sealey Limited
fig.3
01284 703534
Original Language Version
ansWer:
Yes, in accordance with local authority regulations.
room temperature. the PoWErstArt will also operate at temperatures
below zero, however power will be lessened. intense heat will activate self-
discharge.
no, only the supplied charger can be used.
No. All jump starting instructions must be followed carefully.
Yes, through your sealey dealer, but note: Batteries are not covered by
warranty as they are consumable items.
no. the electronic trip will operate if cranked for too long. Do not exceed duty
cycle as stated in section 5.12
Check fuse within the black sleeve on the black clamp. See fig 3A and Section
5.14 (PoWErstArt500.V2 and 900 only)
sales@sealey.co.uk
POWERSTART200 / 500 / 900
www.sealey.co.uk
Issue 7 (H, F, 2) 21/12/17

Advertisement

loading

This manual is also suitable for:

Powerstart500.v2Powerstart900