Advertisement
13. TROUBLESHOOTING
Problem
unit will not start car
the unit will not power a 12V
or usB device.
the display shows
JUMP START READY -
BATTERY COLD REDUCED
PERFORMANCE
the display shows
JUMP START OVERLOAD.
Beeping sound and display
shows
BATTERY LOW - RECHARGE
or BATTERY TOO LOW
the green LED is flashing and
the display shows
RECHARGE - JUMP START
ABORT
the display shows
RECHARGE - JUMP START
ABORT
ENVIRONMENT PROTECTION
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
dispose of this product at the end of its working life in compliance with the eu directive on Waste electrical and electronic equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. contact your local solid
waste authority for recycling information.
BATTERy REMOVAL
separate the two halves of the casing by undoing the screws. unplug the 2 batteries.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack
Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack sealey limited
Possible cause
clamps are not making a good connection to the
battery.
the battery is not charged.
the temperature of the internal battery is above
55°c (131°f).
the vehicle's battery voltage is over 15V.
the vehicle's battery voltage is below 1V.
the outside temperature is less than -10°c (14°f).
the vehicle's battery is defective.
the device is not turned on.
the internal battery is not charged.
the temperature of the jump starter's internal
battery is too low.
over current protection.
the internal battery is discharged.
charging has aborted. the battery is not accepting
a charge.
the battery is low.
01284 703534
Original Language Version
Reason/Solution
check for poor connection to battery and to chassis.
make sure connection points are clean.
check battery charge status, recharge if necessary.
Place the unit in a well ventilated area to cool the
battery.
You can not use this jump starter for this vehicle.
Press and hold the jump start button for 5 seconds,
until display shows JUMP START READY.
try starting several times. if not successful, place the
unit in a warmer area for a short time.
Have the battery checked.
turn on device.
check the battery charge status and recharge if
necessary.
try to jump start a few times to warm up the internal
battery of the jump starter.
Press the jump start button to turn off the unit.
recharge the internal battery.
reset the charger by briefly unplugging the unit. If
problem persists, call sealey stockist.
recharge the battery.
sales@sealey.co.uk
www.sealey.co.uk
sl2s | issue 1 27/07/17
Advertisement
