Opening The Burner; Closing The Burner - Riello RLS 70 Installation, Use And Maintenance Instructions

7.3

Opening the burner

Disconnect the electrical supply from the burner
by means of the main system switch.
DANGER
Close the fuel shut-off valve.
DANGER
Wait for the components in contact with heat
sources to cool down completely.
 Loosen the screws 1) and remove the cover 2)
 Disconnect the light oil pipes 7)
 Remove the screws 3) and move the burner backwards by
about 100 mm on the slide bars 4).
 Disconnect the electrode cables, then completely retract the
burner.
At this point it is possible to extract the inner part 5) after having
removed the screw 6)(Fig. 45).
7.4

Closing the burner

 Push the burner to approximately 100 mm from the pipe
coupling.
 Reconnect the cables and slide in the burner until it comes
to a stop.
 Replace the screws 3) and carefully pull the cables outwards
until they are slightly taut.
 Reconnect the light oil pipes.
Maintenance
After carrying out maintenance, cleaning or
checking operations, reassemble the cover and
all the safety and protection devices of the burner.
39 GB
D1183
Fig. 45
20139915