Assembly - Weider 8920 User Manual

ASSEMBLY

Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. However, it is important to
realize that the versatile weight system has
many parts and that the assembly process will
take time. Most people find that by setting aside
plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
FRAME ASSEMBLY
1. Before beginning assembly, be sure that you
have read and understand the information in
the box above.
Press a 50mm Square Inner Cap (27) into the
end of the Base (4). Press a 50mm Square Outer
Cap (51) onto each end of the Stabilizer (5).
Insert two M8 x 63mm Carriage Bolts (1) up
through the Base (4). Insert two M8 x 67mm
Carriage Bolts (14) up through the Stabilizer (5).
Note: Be sure the indents around holes in the
Stabilizer are on the bottom.
Slide the bracket end of the Base (4) onto the M8
x 67mm Carriage Bolts (14) in the Stabilizer (5).
Slide the Rear Upright (56) onto the Carriage
Bolts. Hand tighten an M8 Nylon Locknut (3) onto
each Carriage Bolt.
• As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART in the center of this
manual.
The following tools (not included) are required
for assembly:
• two adjustable wrenches
• one rubber mallet
• one standard screwdriver
• one Phillips screwdriver
• lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
3
5
51
Indents
14
5
56
51
4
1
27