Roland VersaUV LEF2-300 User Manual page 188

• The height of the head refresher may have been changed from the standard height due to the influence of the jig. In this
situation, set the installation height of the head refresher.
16.
When the following screen is displayed, open the front cover.
REMOVE HEAD
REFRESHER
17.
Open the sheet retaining cover and remove the head cleaning sheet.
Remove the sheet by pinching parts that are clean of ink and cleaning liquid. Use tweezers or gloves if get-
ting cleaning liquid on your hands seems unavoidable.
18.
Check that there are traces of ink being wiped off onto the head cleaning sheet.
IMPORTANT
Quickly dispose of used head cleaning sheets.
Leaving a used head cleaning sheet inside the machine may lead to the machine's painting peeling off.
To purchase head cleaning sheets, contact your authorized Roland DG Corporation dealer or visit our website (
www.rolanddg.co.jp/
Point
• If there are minor traces of ink being wiped off onto the sheet, head refreshing has failed. Check the following points, and
then perform head refreshing again.
• Has the head cleaning sheet been attached in the correct position?
• Is the head cleaning sheet loose?
• Has cleaning liquid soaked into the entirety of the head cleaning sheet?
• Has too much cleaning liquid been applied? (The appropriate amount is two [A] or three [B] drops per cleaning pad.)
• Cleaning pads cannot be used if they are severely deformed (warped or tilted) or are coming free of the unit. Replace the
cleaning pad unit. For information on replacement, contact your authorized Roland DG Corporation dealer.
19.
Remove the head refresher and the head refresher spacer (if it has been attached).
MEMO
You can place the head refresher in the space on the left side of the machine. Do not place anything here other than the head
refresher, head refresher spacer (LEF2-300D), head cleaning sheet, and bottle for head refreshing.
).
Manual Cleaning
https://
2. Regular Maintenance
187