Faults - Causes And Remedies - Beem Latte Creme Instruction Manual

Faults - causes and remedies

Fault
Device cannot be swit-
ched on
The automatic circuit
breaker in the fuse box
trips.
Device does not switch
off automatically
Milk froths over
Frothing is not satis-
factory
NOTE
If you cannot resolve the problem with the steps described
►
above, please contact customer service.
BEEM - Elements of Lifestyle
Possible cause
Plug not inserted into
mains socket
Automatic circuit breaker
in fuse box tripped
Milk container (1) does not
sit properly on the base
plate (6)
Device is still too warm
from previous use
Too many devices con-
nected to the same power
circuit.
Device is defective
Defective thermostatic
switch
Milk container (1) too full
Frother (4) is not sitting
properly on the holding
pin (8)
Frother (4) and/or holding
pin (8) dirty/stuck
Troubleshooting
Remedy
Insert plug
Switch on the auto-
matic circuit breaker
again
Place the milk con-
tainer (1) properly in
the middle of the base
plate (6)
Allow the device to
cool down (e.g., rinse
with cold water)
Reduce the number of
devices on the power
circuit.
Contact customer
service.
Disconnect device
from the mains and
contact customer
service
Pay attention to
the maximum filling
quantity
Put the frother (4) pro-
perly onto the holding
pin (8)
Clean frother (4) and/
or holding pin (8)
EN
51